The article presents a study of the possible use of materials with Shape Memory Effect (SME) in shipbuilding, which have two special abilities of transformation and changing shape with changing of temperature or deformation. Among the most well-known SME materials, our study focuses on Ni-Ti and Cu- based alloys. An example of the existing fabrication presents casting of Ni-Ti in the form of a disk, and a new approach – continuous casting of Ni-Ti and CuAlNi alloys in the form of rods. In the article some results are shown of characterisation of microstructure and the basic properties. This was done in accordance with the fact that such scientific approach could define the starting point for further identification of the functional characteristics of these alloys by knowing the their chemical content and microstructure. Numerous studies are being carried out today in order to find the optimal functional characteristics of SME alloys. All of this is aimed at optimising the fabrication of these alloys, with the achievement of suitable properties for application in shipbuilding.
AbstractMonitoring of the corrosion process of alloys in real conditions often results in extensive data, which is characterized by complex interdependence, but by a large degree of mutual deviation. First of all, the large dispersion of the obtained results makes it very difficult to draw accurate conclusions about the real influence of the tested parameters on the corrosion behavior of alloys. On the other hand, in many cases, the high interdependence between the corrosion factors can also greatly...
The analysis of the behaviour of new materials in the natural environment is important for their application and commercial use. In order to explore the application of Shape Memory Alloys in the Maritime industry, this research focuses on the corrosive behaviour of the NiTi rod that was produced by means of a continuous casting process. The experiment included three samples of NiTi rods that were exposed to the marine environment for 6, 12 and 18 months at a depth of 3 metres below the surface....
The article presents a study of the possible use of materials with Shape Memory Effect (SME) in shipbuilding, which have two special abilities of transformation and changing shape with changing of temperature or deformation. Among the most well-known SME materials, our study focuses on Ni-Ti and Cu- based alloys. An example of the existing fabrication presents casting of Ni-Ti in the form of a disk, and a new approach – continuous casting of Ni-Ti and CuAlNi alloys in the form of rods. In the article...